1/31/2024 0 Comments Angry ip scanner all hosts appearSo the IP address of 192.168.100.0/24 subnet will be assigned to the PC connected to this VPN. So the IPv4 configuration of one of the PC in VLAN 10 looks like this:įor Meraki's Client VPN configuration, I set the subnet as 192.168.100.0/24. There's no DNS/WINS server nor Domain set up in this network. Some other PCs are also connected to VLAN 10, some are Windows PCs and some are Linux based video processors and Synology NAS (also running on Linux), all of them have a static IP of 192.168.10.0/24 subnet. Then I set the IP address of the Meraki MX as 192.168.10.254Īnd added a default route on the Netgear switch from the Route Configuration page and set this 192.168.10.254 as the Next Hop Address. I went to VLAN Static Routing Wizard on the Netgear web configuration page and created VLAN 10 as below There are three VLANs configured on this switch: VLAN10, VLAN20, VLAN30. I've also set up VLAN routing on the Netgear Switch S3300-52X-PoE+ and shared internet (which is from Meraki MX) across different VLANs. So I have a Client VPN setup using Cisco Meraki MX. This may be a very basic question but I couldn't find a good explanation for this even after spending a lot of time searching on the internet as I'm complete a beginner with a very basic knowledge of networking but I'm eager to learn.Would very much appreciate it if anyone can advise me on this :)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |